Site Logo E-PROJECTTOPICS

COMPARATIVE ANALYSIS OF THE AMINOLYSIS OF POLYETHYLENE TEREPHTHALATE WASTE AND SODIUM DICHROMATE AS CORROSION INHIBITORS FOR MILD STEEL IN 0.5M HCL AND 0.5M H2SO4


ðŸ“


Presented To


Engineering Department

📄 Pages: 84       🧠 Words: 11311       📚 Chapters: 5 🗂ï¸ï¸ For: PROJECT

ðŸ‘ï¸â€ðŸ—¨ï¸ï¸ï¸ Views: 257      

â¬‡ï¸ Download (Complete Report) Now!

ABSTRACT
Waste coca cola plastic bottles were subjected to depolymerization by aminolysis using mono ethanol amine (MEA) in the presence of sodium acetate as catalyst, the product bis(2-hydroxy ethylene terephthalate amide (BHETA) was compared with sodium dichromate (Na2Cr2O7) as corrosion inhibitors for mild steel in 0.5M HCl and 0.5M H2SO4 at ambient temperature. Results indicated that the rate of corrosion of the mild steel increased in the absence of both inhibitors and decreased with increase in concentration. The effect of temperature on the corrosion behavior of mild steel in the presence of 571, 1142, 1714 and 2285ppm inhibitor concentrations was also studied. The associated activation energy of corrosion and other thermodynamic parameters such as enthalpy of adsorption (ΔHads), adsorption equilibrium constant (Kads) and standard free energy of adsorption (ΔGads) were calculated. Highest inhibitor efficiency of BHETA was 84.5% in HCl and 82.9% in H2SO4 at 303K and 1714ppm concentration; lowest inhibitor efficiency of 74.8% in HCl and 61.8% in H2SO4 was recorded at 333K and 571ppm respectively. Na2Cr2O7 had highest inhibitor efficiency of 95.4% in HCl and 79.8% in H2SO4 at 303K and concentration of 1714ppm. Lowest inhibitor efficiency of 64.5% in H2SO4 and 84% in HCl was recorded at 333K and inhibitor concentration of 571ppm. Inhibitor efficiency increased with increasing concentration and decreased with increasing temperature. The values of activation energy (Ea) and free energy of adsorption indicated that the type of adsorption on the surface of mild steel is physically controlled, exothermic and spontaneous. Optical microscope (OMS) was used to study the surface morphology of mild steel in the absence and presence of both inhibitors. BHETA however surpassed Na2Cr2O7 in its corrosion inhibition ability in H2SO4, while the corrosion inhibition ability of Na2Cr2O7 in HCl was better than BHETA. Nevertheless, BHETA is a good substitute for Na2Cr2O7 and it is recommended on the basis of low operational hazard and better inhibition in H2SO4

PLEASE NOTE

This material is a comprehensive and well-written project, structured into Chapter (1 to 5) for clarity and depth.


To access the full material click the download button below


OR


Contact our support team via Call/WhatsApp: 09019904113 for further inquiries.

Thank you for choosing us!

📄 Pages: 84       🧠 Words: 11311       📚 Chapters: 5 🗂ï¸ï¸ For: PROJECT

ðŸ‘ï¸â€ðŸ—¨ï¸ï¸ï¸ Views: 257      

â¬‡ï¸ Download (Complete Report) Now!

🔗 Related Topics

ANALYSIS AND OPTIMISATION OF INTER CELL HANDOVER DYNAMICS IN A GSM NETWORK GEOGRAPHIC INFORMATION SYSTEM-BASED TRAFFIC ANALYSIS ZONING OF FEDERAL CAPITAL CITY (FCC) THE STRUCTURAL BEHAVIOUR AND ULTIMATE STRENGTH OF REINFORCED CONCRETE SLABS SRENGTHENED BY EPOXY-BONDED STEEL PLATES THE STUDY OF HARDENING CHARACTERISTICS OF HIGH CARBON STEELS AND DUCTILE CAST IRON EFFECTS OF AFRICAN BASIL(Ocimumgratissimum) AND BUSH MINT(Hyptissuaveolens) LEAVES EXTRACTS IN INHIBITING CORROSION OF MEDIUM CARBON STEEL IN 0.5M OF HCl, H2SO4 AND NaCl MEDIA DESIGN AND USE OF A MODEL CONSTRUCTED HORIZONTAL SUBSURFACE FLOW WETLAND FOR TREATING TANNERY WASTEWATER BY MEANS OF AQUATIC PLANTS A COMBINED BIOGAS PLANT AND INCINERATOR SYSTEM FOR MUNICIPAL SOLID WASTE MANAGEMENT EVALUATION OF SOME PLANT EXTRACTS AS CORROSION IN HIBITORS FOR Al – 7.0 % Si – 0.35 % Mg ALLOY IN 3.5 % NaCl AQUEOUS SOLUTION FAILURE ANALYSIS AND DEVELOPMENT OF HIGH WEAR RESISTANT LOCALLY- MANUFACTURED GOLD - MILL GRINDING PLATES BRONZE IMMERSION PLATING ON MILD STEEL IN CYANTDE-FREE SOLUTIONS DEVELOPMENT OF A SENSITIVITY INDEX BASED TECHNIQUE FOR UNIFIED POWER FLOW CONTROLLER PLACEMENT WITH CONTINGENCY ANALYSIS ON NIGERIA 330kV TRANSMISSION NETWORK FAILURE COST ANALYSIS OF HUMAN ERRORS IN REINFORCED CONCRETE BEAM CONSTRUCTION RELIABILITY-BASED DESIGN RULES FOR THIN-WALLED STRUCTURAL STEEL BEAM-COLUMN ELEMENTS COMPARISON OF FLOOD FREQUENCY ANALYSIS METHODS FOR RIVER TARABA EFFECTS OF INHIBITORS ON CORROSION OF LOW CARBON STEEL IN HYDROCHLORIC ACID PICKLING SOLUTION ANALYSIS AND OPTIMISATION OF INTER CELL HANDOVER DYNAMICS IN A GSM NETWORK HYDRAULIC AND CONTAMINANT TRANSPORT PERFORMANCE OF COMPACTED LATERITIC SOIL– BENTONITE MIXTURES PROPOSED AS WASTE CONTAINMENT BARRIER THE USE OF MANGO (MANGIFERA INDICA) SEEDS AND DATES (PHOENIX DACTYLIFERA) SEEDS AS COAGULANTS IN WASTEWATER TREATMENT RELIABILITY ANALYSIS OF HIGH VOLTAGE POWER EQUIPMENT IN AJAOKUTA STEEL COMPANY LIMITED (ASCL) EFFECT OF ORANGE PEEL, WATERMELON PEEL, AND THEIR SYNERGISTIC EFFECT ON THE REMOVAL OF HEAVY METALS FROM DYE WASTEWATER

click on whatsapp